Idaho Stair NoseCustom LVP stair nosing · Nampa & Idaho Falls

Install guide

How to Install LVP Stair Nose

Every LVP stair gets glued, never floated. Each step takes three pieces — the bent nose we make, plus a flat back fill and a riser you cut from your flooring. Most DIYers finish 12–14 stairs in a few hours plus cure time.

2Flat back pieceYou cut it from your flooring1Bent nose pieceWe make this · ~60% of tread3Flat riser piece
You'll install three pieces per step; we make piece 1. Pieces 2 and 3 are straight cuts from your flooring.
  1. 1

    Measure

    Count the stairs. Measure each tread's width side-to-side and depth front-to-back. Note anything over 48" long or 15" deep.

  2. 2

    Prep the treads

    Remove old nosing or carpet. You want bare, clean, flat, dry wood treads.

  3. 3

    Order your nose pieces

    Price it, text the order, and drop off one plank per stair if you're using your own. Pick up same or next day.

  4. 4

    Dry-fit

    Set each nose, back fill and riser piece in place before any glue goes down.

  5. 5

    Glue everything

    Use Roberts 7350 Universal on the nose and both flat pieces. Floating or click installs don't work on stairs — they shift and squeak.

  6. 6

    Work bottom to top

    Covering risers with the same LVP? Start at the bottom: riser, then nose, then back fill, so each riser tucks under the nose above it. Painted risers? Start at the top or bottom.

  7. 7

    Press, weight and cure

    Press each piece firmly and weight it while the adhesive cures.

  8. 8

    Finish the top step

    If the floor runs a different direction, trim the tongue off the nose and the adjoining plank so they butt cleanly, and glue generously under the joint.

  9. 9

    Caulk the back seam

    Finish with color-matched caulk where the back fill meets the riser above.

See it in cutaway

Side view of a wood-look LVP stair tread with stair nose wrapping over the front edge above a matching riser.
Wood-look LVP stair nose wraps over the tread’s front edge above a matching riser.
Cutaway of a wood-look LVP stair tread with a wrapped stair nose over a white riser.
This cutaway shows a wood-look LVP stair tread and wrapped stair nose above a white riser.
Wood-look LVP stair tread with a square stair nose edge and a Roberts 7350 adhesive container behind it.
A wood-look LVP stair tread wraps over a square stair nose edge, with Roberts 7350 adhesive visible behind it.

Ready to order?

Text the store closest to you. We'll reply to confirm pickup time.

Text Nampa Text Idaho Falls
Text Nampa Text Idaho Falls